About us|News|Products|Banks|Contact
Japan Spanish English
Hexagonal Wire Netting
Gabion
Reinforced gabions
Heavy hexagonal wire netting
Galvanized gabion
PVC Coated Gabions
Zinc-aluminum alloy gabion
Stainless steel gabions
Gabions
gabions baskets
Welded Gabion box
Gabion box
Reno Mattress
Sack Gabions
Rockfall nettings
Gabion terramesh
Green terramesh
Gabions with geotextiles
Slope type gabions
Installation of gabions
Installation of reno mattresses
Installation of sack gabions
Installation of Gabion box
Application of gabions
Water Conservancy
Gabion retaining wall
Bridge Protection system
Gabions for channel linings
Revetment gabions
Gabion rockfall embankment protection
Gabion Mesh Machine
Welded Gabions
Garden Gabion
Welded gabions
Chainlink mesh gabions
SNS flexible protection mesh
Knowledge: You are here: Home - News

Fabrication of gabions

Fabrication of gabions
Gabions shall be fabricated in such a manner that the sides, ends, lid and diaphragms can be assembled
at the construction site into rectangular baskets of the sizes specified and shown in the drawings.
 Gabions shall be of single unit construction: the base, lid, ends and sides shall be either woven into a
single unit or edge of these members connected to the base section of the gabion in such a manner that
 strength and flexibility at the connecting point does not compromise the engineered structural design of
 the gabion. Where the length of the gabion exceeds one and one half its horizontal width,
the gabion shall be divided by diaphragms of the same mesh and gauge as the body of the gabion,
into cells whose length does not exceed the horizontal width. The gabion shall be furnished with the
necessary diaphragms secured in proper position on the base in such a manner that no additional tying is
required at this juncture.
Mesh Formation:
The double twisted hexagonal wire mesh shall have deformability sufficient to permit minimum of mesh
elongation equivalent to 10% of the unstretched length of the mesh test section without reducing the
gauge or the tensile strength of the individual wire strands to values less than those for similar wire,
one gauge smaller in diameter.
Non-raveling:
The wire mesh is to be fabricated in such a manner as to be non raveling. This is defined as the ability
 to resist pulling apart at any of the twists or connections forming the mesh when a single wire strand
 in a section of mesh is cut.

|||||||
All HeShuoMetalProducts Co.,Ltd. TEL:86-311-86987533 FAX:86-311-86986623 Email:gabion@gabionmesh.com